Amtek Critter Gitter Voltage Regulator Technical Information
Parameters:
Input voltage: 5-32.0v (I suggest not running it at its maximum)
Output voltage: 0-30.0v
Output current: 1.5A max
Output power 30W Max.
Output voltage resolution: 0.1v
Voltage testing accuracy: +/- (1% + 2 digits)
Wiring:
IN+: Connect IN+ to your input positive
IN-: Connect IN+ to your input negative (ground)
OUT+: Connect OUT+ to your output positive
IN-: Connect OUT+ to your output negative (ground)
Output current: 1.5A max
Output power 30W Max.
Output voltage resolution: 0.1v
Voltage testing accuracy: +/- (1% + 2 digits)
How to use:
On/OFF is the output voltage control button. It turns the output voltage on and off. Push for ON. Push again for OFF.
The two buttons labeled IN and OUT (on the left side of the digital display) swith the display between showing the input voltage and the output voltage.
The Set button sets the output voltage. Press SET once and the decimal part of the output voltage flashes. Press + or - buttons on the left side to raise or lower the decimal part of the output voltage.
Press SET again and the voltage value flashes. Perss the + or - buttons on the left to set the output voltage non-decimal value.
Press SET again to return to normal operation.
Note: After pressing the SET button the "setting" mode automatically returns to normal operation after 6 seconds.
Notes:
Be sure to use this module within its working range. Over voltages cause heating. Do not short the output + and - or the board will burn.
Made in USA
Toll
Free: (844) 243-0255